Italiano   English   
Sponsors - Ideal Water Solution

Added New Phone Number 0039.0773.52.30.14

Everpure MicroGuard™ Pro4 replacement filter 13.600lt. - 3,8lt./min 0,15 micron (6)

  • Model: 963702
  • Shipping Weight: 0.3lbs
  • Manufactured by: Everpure


Everpure MicroGuard Pro4
Hollow fibers and carbon block filter media, 0.15 micron rating, absolute barrier against bacteria broad-spectrum. Removes Giardia cysts and Cryptosporidium, asbestos fibers, taste and odor, chlorine, dirt, rust, suspended material not visible at naked eye, mold and algae. Reduction of oxidized iron, manganese and sulfides.


* Ideal for drinking and cooking in maximum safety.
* Improve taste of beverages, sparkling water.
* Protect from clogging, corrosion and wear.
* No electrical connection required.
* Vertical installation.
* The rapid filter is easy to install and replace without use of special tools.

Construction materials
Membrane: polyethersulphone
Uses a membrane in polyethersulfone patented and highly asymmetric with original hydrophilic formulation allowing an immediate wetting and high flows.
Membrane assembled: Polystyrene, epoxy resin
Pre-filter a Coal: 10MCB with technology Fibredyne ™ contains activated carbon with polymeric fibers bound together.
O-ring signet: EPDM

Technical Specifications
Reducing Bacteria:> 99.9999% (> 6-registered), tested with> 50,000,000 organisms per 100 mL.
Reduction organic substancse: Brevundimonas diminuta (higher than 0.2 microns).
Method: USEPA Standard Guide and norms that regulate the purified water, 1987.
Reduction of Cysts:> 99.95% (> 3.3-registered), tested with> 50,000 microspheres for mL.
Method: NSF / ANSI 53 Standard, (experimental protocol utilizing an surrogate of latex microspheres in micron 3.0).
NOTE: Reduction of 99.95% of cysts. (3.3-Log).

* Chlorine reduction
* Bacteriostatic
* Reduction of cysts
* Reduction of particulate in suspension

• Technology: Multistage, carbon block activated
• Micron rating: 0,15 micron
• Service life: 2.200 gallons (13.600 Liters)
** Capacity varies according to:
* Inlet water quality
* Required flow rate
* Inlet water pressure
* Filter use (continuous or intermittent)
• Service flow rate: 3,8 l./Min. (0.5 gpm)
• Temperature: 35 - 100°F (2-38°C)
• Pressure: 10 - 125 psi (0.7 - 8.6 bar), not-shock.
• Size: 2
• Cartridge dimensions HxD: MicroGuard PRO4 368x82,5(mm.) - 14,5”x3.25"(In.)
(Leave a vertical space of about 7 cm under filter to allow replacement).
• Activation: it is advisable to run water through filter at maximum pressure and full flow rate, for at least 5 minutes to allow air purging and flushing of cartridge.
• Cartridges change: When capacity is reached, or when flow comes too slow (precipitates under 0.7bar/10psi), every 6 months but at least annually.

Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used with disinfected water that may contain filterable cysts. All systems must be maintained according to producer instructions.
Note: The contaminants or other substances removed or reduced by this drinking water system are not necessarily in your water.